Filter
Top Products
Basic system management configuration task list 95
SmartWare Software Configuration Guide 7 • Basic system management
Example: Setting the system banner
The following example shows how to set a message for the system banner for your device, if you start from the
configuration mode.
node(cfg)#banner \n#\n# The password of all operators has changed\n# please contact
the administrator\n#"
Setting time and date
All SmartNode devices provide time-of-day and date services. These services allow the products to accurately
keep track of the current time and date. The system clock specifies year, month, day, hour, minutes, and
optionally seconds. The time is in 24-hour format yyyy-mm-ddThh:mm:ss and is retained after a reload.
Mode: Configure
Note The integrated SNTP client allows synchronization of time-of-day and date
to a reference time server. Refer to chapter 26, “SNTP client configuration”
on page 282 for more details.
Example: Setting time and date
The following example shows the commands used to set the system clock of your device to August 6, 2001 at
16:55:57, if you start from the operator execution mode.
node(cfg)#clock set 2001-08-06T16:55:57
Display clock information
This procedure describes how to display the current date and time
Mode: Both in operator and administrator execution
Example: Display clock information
The following example shows the commands used to display the time and date settings of your device in local
time, if you start from the operator execution mode.
node>show clock
2001-08-06T16:55:57
Step Command Purpose
1 node(cfg)#clock set yyyy-mm-ddThh:mm:ss Sets the system clock to yyyy-mm-ddThh:mm:ss
Step Command Purpose
1 node>show clock Display the local time.