Filter
Top Products
Basic IP routing configuration task list 238
SmartWare Software Configuration Guide 22 • Basic IP routing configuration
Deleting static IP routes
The
no form of the route command deletes a static IP route from the routing table.
This procedure describes how to delete one or more static IP routes from the routing table
Mode: Administrator execution
Example: Deleting a static IP route
In the following example, the route for packets to network 20.0.0.0/24, which are routed to device with IP
address 172.17.100.2, shall be deleted.
node>enable
node#configure
node(cfg)#context ip router
node(ctx-ip)[router]#no route 20.0.0.0 255.255.255.0 172.17.100.2
Displaying IP route information
This procedure describes how to display static IP routes
Mode: Operator or administrator execution
This command displays the destination address, next-hop interface, protocol (local, static, RIP, or ICMP),
metric, flags (U–up, H–host, G–Gateway, L–local, D–default), and amount of use for each route in the routing
table. If there are multiple routes to the same destination, the preferred route is indicated by an asterisk (*).
Example: Displaying IP route
In the following example, IP route information is displayed.
node>show ip route
Routes of IP context 'router':
Status codes: * valid, U up, H host, G Gateway, L local, D default
Destination Nexthop Protocol Metric Flags Used
---------------------------------------------------------------------
* 127.0.0.1/32 local 0 LHG n/a
* 172.16.40.77/32 local 0 LHG n/a
* 172.17.100.210/32 local 0 LHG n/a
* 172.17.100.0/24 wan local 1 UL 0
* 20.0.0.0/24 172.17.100.2 static 0 U 0
* 172.16.0.0/16 lan local 1 UL 6
Step Command Purpose
1 node(cfg)#context ip router Enters the IP router context
2 node(ctx-ip)[router]#no route network mask {address | interface} Deletes a static route
Step Command Purpose
1 node>show ip route Displays IP route information