Filter
Top Products
31
SmartWare Software Configuration Guide About this guide
Structure
This guide contains the following chapters and appendices:
• Chapter 1, "System overview" on page 38 provides an overview of the main elements of a SmartWare system.
• Chapter 2, "Configuration concepts" on page 44 introduces basic SmartWare configuration concepts.
• Chapter 3, "Command line interface (CLI)" on page 49 gives an overview of the CLI and the basic features
that allow you to navigate the CLI and edit commands effectively.
• Chapter 4, "Accessing the CLI" on page 53 describes the procedures for entering SmartWare commands via
the command line interface (CLI), to obtain help, to change operator mode and to terminate a session.
• Chapter 5, "System image handling" on page 65 describes how to load and maintain system images and
driver software.
• Chapter 6, "Configuration file handling" on page 76 describes how to upload and download configuration
files from and to a SmartNode.
• Chapter 7, "Basic system management" on page 90 describes parameters that report basic system informa-
tion to the operator or administrator, and their configuration.
• Chapter 8, "RADIUS Client Configuration" on page 102 provides an overview of the authentication,
authorization, and accounting (AAA) component in SmartWare and describes how to configure the
RADIUS client, a subpart of the AAA component.
• Chapter 9, "IP context overview" on page 114 outlines SmartWare Internet protocol (IP) context, together
with its related components.
• Chapter 10, "IP interface configuration" on page 120 provides a general overview of SmartNode interfaces
and describes the tasks involved in their configuration.
• Chapter 11, "NAT/NAPT configuration" on page 132 provides a general overview of the network address
port translation and describes the tasks involved in its configuration.
• Chapter 12, "Ethernet port configuration" on page 141 provides an overview of Ethernet ports and
describes the tasks involved in their configuration through SmartWare.
• Chapter 13, "Link scheduler configuration" on page 151 describes how to use and configure SmartWare
quality of service (QoS) features.
• Chapter 14, "Serial port configuration" on page 170 provides an overview of the serial port and describes
the tasks involved in its configuration through SmartWare.
• Chapter 15, "Frame Relay configuration" on page 177 provides an overview of how to configure frame relay
through SmartWare.
• Chapter 16, "PRI port configuration" on page 191 provides an overview of the T1/E1 ports, their charac-
teristics and the tasks involved in the configuration.
• Chapter 17, "BRI port configuration" on page 205 provides an overview of the BRI (Basic Rate Interface)
ports, their characteristics and the tasks involved in the configuration.
• Chapter 18, "ISDN Overview" on page 212 provides an overview of ISDN ports and describes the tasks
involved in configuring ISDN ports in SmartWare.