Filter
Top Products
Gateway configuration task list 553
SmartWare Software Configuration Guide 45 • H.323 gateway configuration
For example to disable signature verification of RCF messages enter the command no h235-security ras-
auth-int-rx rcf
. When not specifying the message type, you change the behavior of all message types. Addi-
tionally there are special message-types that manipulate the behavior of message-groups:
'request' ==> ARQ, BRQ, DRQ, GRQ, IRQ, LRQ, RAI, RRQ, SCI, URQ
'response' ==> ACF, BCF, DCF, GCF, IACK, IRR, LCF, RAC, RCF, RIP, SCR, UCF
'reject' ==> ARJ, BRJ, DRJ, GRJ, INAK, LRJ, RRJ, URJ
E.g. 'no h235-security ras-auth-int-rx reject' disables verification of the H.235
signature of all received reject messages, e.g. GRJ, RRJ, ARJ.
The default setting is:
h235-security ras-auth-int-rx request
h235-security ras-auth-int-rx response
no h235-security ras-auth-int-rx reject
h235-security ras-auth-int-tx request
h235-security ras-auth-int-tx response
no h235-security ras-auth-int-tx reject
The command show h235-security shows the current setting.
7 node(gw-h323)[h323]#h235-security ras-
auth-int-tx [<msg>]
or
node(gw-h323)[h323]#no h235-security
ras-auth-int-tx [<msg>]
Enables or disables H.235 security for trans-
mitted RAS packets. msg is the message type.
8 node(gw-h323)[h323]#h235-security q931-
auth-int
or
node(gw-h323)[h323]#no h235-security
q931-auth-int
Enables or disables H.235 security for call-
signaling.
9 node(gw-h323)[h323]#h235security If all parameters are set, enables H.235 secu-
rity. Otherwise returns an error message.
10 node(gw-h323)[h323]#show h235security Shows status of H.235 security module.
11 node(gw-h323)[h323]#debug h235security
[detail debug-level]
Enables the H.235 debug monitor to display
information for every received and sent H.323
signaling message.
Step Command Purpose