Filter
Top Products
RIP configuration task list 251
SmartWare Software Configuration Guide 23 • RIP configuration
Displaying RIP configuration of an IP interface
Displaying the RIP configuration of an IP interface is useful to list the settings. This procedure describes how
to display the RIP configuration of an interface
Mode: Interface
Example: Displaying RIP configuration of an IP interface
The following example shows how to display the RIP configuration of IP interface wan.
node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#show rip interface wan
Interface wan (IP context router):
--------------------------------------------------
listen: disabled
supply: enabled
send version: 1compatible
receive version: 1or2
learn host: disabled
learn default: disabled
announce host: disabled
announce static: disabled
announce default: disabled
announce self-as-default: disabled
route-holddown: enabled
poison-reverse: disabled
auto-summary: disabled
split-horizon: disabled
default-route-value: 0
--------------------------------------------------
Displaying global RIP information
SmartWare also support displaying global RIP information for the IP router context. This procedure describes
how to display the global RIP information
Mode: Configure
Example: Displaying global RIP information
The following example shows how to display the global RIP information.
node(cfg)#show rip
RIP information:
Step Command Purpose
1 node(if-ip)[name]#show rip interface ifname Displays the RIP binding of an IP interface on
name
Step Command Purpose
1 node(cfg)#show rip Displays the RIP information