Filter
Top Products
Location Service configuration task list 617
SmartWare Software Configuration Guide 51 • Location Service
Mode: Call outbound
Mode: Call outbound
Mode: Call outbound
Call inbound face
The call inbound face is used to configure call properties for incoming calls.
Mode: Identity
Mode: Call inbound
Step Command Purpose
1 [node](callout)#proxy <index> down <posi-
tions>
or
[node](callout)#proxy <index> up <posi-
tions>
If multiple proxies are configured the entry at the
index can be moved in the proxy list up or down
the number of positions given in the command.
Step Command Purpose
1 [node](callout)#no proxy [<index>] Removes the proxy entry at the index or remove all
proxy entries if no index is given.
Step Command Purpose
1 [node](callout)#proxy none Removes all proxy entries and disables explicitly
the use of a proxy.
Step Command Purpose
1 [node](identity)[name]# [no] call inbound Adds a new face to the identity. The no form of the
command removes an existing face with all content
in it.
Step Command Purpose
1 [node](callin)[name]# [no] use profile
(sip|tone-set|voip) <profile>
Adds or removes a profile to use if an incoming
call destines this identity.