Filter
Top Products
PPP configuration task list 324
SmartWare Software Configuration Guide 30 • PPP configuration
Displaying PPP configuration information
This section shows how to display and verify the PPP configuration information.
Mode: Configure
Example: Display PPP subscriber configuration information
node(session)[green]#show subscriber ppp joe_example
Subscribers:
------------
Name: joe_example
Direction: dial-out
Authentication: pap
Identification (inbound): (none)
Identification (outbound): patton/patton
Timeout for disconnect: no absolute timeout, no idle timeout
Max. sessions: no limit
IP address: (none)
Callback: (none)
Binding: interface ppp_interface router
Binding: interface ppp_interface router
Step Command Purpose
1 node(cfg) #show running-config Gives the best overview of all PPP related configura-
tion information. The following parts are of interest:
• profile ppp default
• profile ppp name
• interface name
• subscriber ppp name
• port ethernet slot port
• session name
2 node(cfg) #show subscriber ppp [ name ] Displays configuration information of the PPP sub-
scriber name or of all PPP subscribers
3 node(pf-ppp)[name]#show profile ppp
{ name | default }
Displays the PPP profile name or the default PPP
profile