Filter
Top Products
Location Service configuration task list 615
SmartWare Software Configuration Guide 51 • Location Service
Registration inbound face
The registration inbound face is used when you want to allow external user agents to register, so that you can
route calls to the registered contacts.
Mode: Identity
Mode: Registration inbound
Mode: Registration inbound
Step Command Purpose
1 [node](identity)[name]# [no] registration
inbound
Adds a new face to the identity. The no form of the
command removes an existing face with all content
in it.
Step Command Purpose
1 [node](regin)# [no] lifetime [default <sec-
onds>] [min <seconds>] [max <seconds>]
Configures the range of the expiration time
accepted for inbound registration. If there is a time
requested which is out of the range the time is set
to a value which fits the range. If there is no time
requested it is set to the default lifetime.
Step Command Purpose
1 [node](regin)# [no] contact <host> [<port>]
<context cs> <interface sip> [priority <prom-
ille>
Adds a contact to the registration inbound face.
The interface and context parameter defines where
the sip-location-service routes a call destined to
that contact. The higher priority a contact has the
sooner a contact is chosen. The default priority is
1000 which is also the maximum priority. The no
form of the command removes a contact.