Patton electronic SmartNode 4110 Series IP Phone User Manual


 
Activating CS context configuration 353
SmartWare Software Configuration Guide 31 • CS context overview
We enable DTMF relay and specify codec G.723. (Refer to section “Configuring voice over IP parameters”
on page 347).
We define H.323 direct call signaling. (Refer to section “Configuring an H.323 VoIP connection” on
page 348).
Configuring general CS settings
First we set clock-source to ISDN port 2/3.
node>enable
node#configure
node(cfg)#system
node(sys)#clock-source 2 3
node(sys)#exit
node(cfg)#
Configuring call routing
Next we create the ISDN interfaces and configure call routing. Each interface is configured to route all incom-
ing calls to the routing table TAB-CALLED-NUMBER. This table is part of the call router and configured
below:
node(cfg)#context cs
node(ctx-cs)[switch]#interface isdn IF-PBX1
node(if-pstn)[IF-PBX1]#route call dest-table TAB-CALLED-NUMBER
node(if-pstn)[IF-PBX1]#exit
node(ctx-cs)[switch]#interface isdn IF-PBX2
node(if-pstn)[IF-PBX2]#route call dest-table TAB-CALLED-NUMBER
node(if-pstn)[IF-PBX2]#exit
node(ctx-cs)[switch]#interface isdn IF-PUBLIC-PSTN1
node(if-pstn)[IF-PUBL~]#route call dest-table TAB-CALLED-NUMBER
node(if-pstn)[IF-PUBL~]#exit
node(ctx-cs)[switch]#interface isdn IF-PUBLIC-PSTN2
node(if-pstn)[IF-PUBL~]#route call dest-table TAB-CALLED-NUMBER
node(if-pstn)[IF-PUBL~]#exit
node(ctx-cs)[switch]#
In addition, we create the two H.323 interfaces and configure call routing, as well as the IP address of the
remote H.323 terminal, which is the IP address of the device in office A or office B, respectively.
node(ctx-cs)[switch]#interface h323 IF-COMPOFF-A
node(if-h323)[IF-COMP~]#route call dest-table TAB-CALLED-NUMBER
node(if-h323)[IF-COMP~]#remoteip 146.86.130.11
node(if-h323)[IF-COMP~]#bind gateway h323
node(if-h323)[IF-COMP~]#exit
node(ctx-cs)[switch]#interface h323 IF-COMPOFF-B
node(if-h323)[IF-COMP~]#route dest-table calledNumberRouting
node(if-h323)[IF-COMP~]#remoteip 146.86.130.24
node(if-h323)[IF-COMP~]#bind gateway h323
node(if-h323)[IF-COMP~]#exit
node(ctx-cs)[switch]#