Filter
Top Products
Creating and configuring CS interfaces 383
SmartWare Software Configuration Guide 33 • CS interface configuration
page 529 and chapter 47, “VoIP profile configuration” on page 573. To create and configure CS interfaces you
have to perform the configuration tasks listed below.
• Creating and configuring CS interfaces
• Configuring call routing
• Configuring the interface mapping tables (optional)
• Configuring the precall service tables (optional)
• Configuring interface type specific parameters
Creating and configuring CS interfaces
To configure CS interfaces, you must first enter the CS context mode where you can create and configure your
required interface through the CS interface configuration mode. Each interface has a name that can be any
arbitrary string of not more than 25 characters. Use a name describing the purpose of the interface, as shown in
the examples or—for ease of identification—the interface type can be used as part of the name. Already-
defined CS interfaces can be displayed or deleted as described in the following table.
Procedure: Create and configure CS interfaces.
Mode: Configure
Examples: Create CS interfaces and delete another
Step Command Purpose
1
node(cfg)#context cs Enter the CS Context Configuration Mode.
2
node(ctx-cs)[switch]#interface if-type if-
name
Enter the CS Interface Configuration Mode & select
the CS interface with type if-type and name if-name
for configuration. Valid interface types are h323,
sip, isdn and fxs.
3
node(if-type)[if-name]#… Perform the configuration tasks to configure the CS
interface.
4
node(ctx-cs)[switch]#show call-control
provider
Display the configuration of the current CS interface.
5
node(if-type)[if-name]#exit Go back to the CS Context Configuration Mode
6
Repeat step 1 to 5 to create and configure your CS
interfaces
7
node(ctx-cs)[switch]#show call-control
provider
or
node(ctx-cs)[switch]#show call-control
status
Display already defined CS interfaces.
Note: The show call-control provider command can
also be used to display the configuration details of a
provider either by specifying its name as a parame-
ter or by being inside its configuration mode.
8
node(ctx-cs)[switch]#no interface if-type if-
name
Delete an existing interface.