Filter
Top Products
Gateway configuration task list 557
SmartWare Software Configuration Guide 45 • H.323 gateway configuration
Setting the connect timeout
Per default the H.323 gateway waits for 60s when the call is in the alerting phase for the call to be answered. If
the call is not answered within that time, the call is dropped. The value of this timer can be changed using the
following procedure:
Mode: Gateway H.323
Example: Defining an alternate connect timeout
The following example shows how to define an alternate connect timeout of 20 seconds on an already defined
H.323 Gateway.
node(cfg)#gateway h323 h323
node(gw-h323)[h323]#timeout connect 20
Configuring the terminal type for registration with the gatekeeper
H.323 gatekeepers may differentiate between two terminal types (terminals and gateways) of the registrant. In
some applications it is necessary for the gateway to register as a terminal, while in other applications it is neces-
sary to register as a gateway.with the gatekeeper. The default terminal type is gateway. It can be changed using
the following procedure: Usually you do not need to change this setting.
Procedure: Configure the registration type of the registration with the gatekeeper
Mode: Gateway H.323
Example: Configuring RAS registration type
The following example shows how to configure the RAS registration type.
node(cfg)#gateway h323 h323
node(gw-h323)[h323]#terminal-type gateway
Step Command Purpose
1
node(gw-h323)[h323]# timeout connect sec-
onds
Defines the connect timeout in seconds.
Step Command Purpose
1 node(gw-h323)[h323]#terminal-type { termi-
nal | gateway }
Set the registration type of the gatekeeper reg-
istration.