Filter
Top Products
The AAA component 105
SmartWare Software Configuration Guide 8 • RADIUS Client Configuration
3. Query the local database (see “Configuring the local database accounts” on page 111 for information on
how to configure the local database)
If, e.g. radius_deepblue is not available, radius_extern will be queried after a timeout. But if radius_deepblue
gives an answer that rejects the login request, the remaining methods are not used and the login is denied. The
same applies to the console service, which uses the profile console-login. This profile uses the following sequence
of methods:
1. Ask radius server radius_deepblue.
2. Ask predefined method none. This method always grants access as system operator.
If radius_deepblue is not available, access will be granted by the method none. If radius_deepblue rejects the
login request, console access is denied. If radius_deepblue confirms the request, console access is granted.
Do the following to configure the AAA component.
Mode: Configure
Example: Create the AAA profiles for login over Telnet and login over console, as they are shown in figure 15,
and use them on the Telnet login and console login services.
node>enable
node#configure
node(cfg)#profile authentication remote-radius
node(pf-auth)[remote-~]#method radius radius_deepblue
node(pf-auth)[remote-~]#method radius radius_extern
node(pf-auth)[remote-~]#method local
node(pf-auth)[remote-~]#server-timeout 15
Step Command Purpose
1 node(cfg)#profile authentication name Creates an authentication profile with name
name and enters profile authentication configura-
tion mode.
2 node(pf-auth)[name]#method [index]
{local | none | {radius name}}
Adds an AAA method to the profile. For RADIUS
you have to specify a name. For information on
how to configure local accounts and RADIUS
servers, refer to chapter 9, “IP context overview”
on page 114. With index you can add a method
between to others.
3 Repeat step 2 for all AAA methods you want to
add
4 node(pf-auth)[name]#server-timeout
seconds
Sets the timeout after that the next AAA method
in the list is requested if no answer is received.
5 node(pf-auth)[name]#exit Goes back to the parent configuration mode
6 node(cfg)#terminal Telnet use
authentication profile-name
Specifies which AAA profile the Telnet login service
has to use.
7 node(cfg)#terminal console use
authentication profile-name
Specifies which AAA profile the console login
service has to use.
8 node(cfg)#show profile authentication
[name]
Displays the configured profiles