Support User Manuals

Patton electronic SmartNode 4110 Series IP Phone User Manual

Open as PDF

of 664

Introduction 142

SmartWare Software Configuration Guide 12 • Ethernet port configuration

Introduction

This chapter provides an overview of Ethernet ports and describes the tasks involved in conﬁguring Ethernet

ports through the SmartWare.

Ethernet port conﬁguration task list

To conﬁgure Ethernet ports, perform the tasks described in the following sections. Most of the task are required to

have an operable Ethernet port, some of the tasks are optional, but might be required for your application.

• Entering the Ethernet port conﬁguration mode (see page 142)

• Conﬁguring medium for an Ethernet port (see page 142)

• Conﬁguring Ethernet encapsulation type for an Ethernet port (see page 143)

• Binding an Ethernet port to an IP interface (see page 143)

• Conﬁguring multiple IP addresses on the Ethernet ports (see page 144)

• Conﬁguring a VLAN (see page 145)

• Conﬁguring layer 2 CoS to service-class mapping for an Ethernet port (advanced) (see page 146)

• Closing an Ethernet port (see page 148)

Entering the Ethernet port conﬁguration mode

To enter port conﬁguration mode and begin conﬁguring an Ethernet port, enter the command

port ethernet

slot port in administrator execution mode. The keywords slot and port represent the number of the respective

physical entity.

Conﬁguring medium for an Ethernet port

All Ethernet ports are conﬁgured by default to auto-sense both the port speed and the duplex mode. This is the

recommended conﬁguration. Command options are (if supported by the platform):

• 10—for 10 Mbps

• 100—for 100 Mbps

• 1000—for Gigabit Ethernet

• auto—for auto-sense the port speed

• half—for half-duplex

• full—for full-duplex

This procedure describes how to conﬁgure the medium for the Ethernet port on slot and port

Mode: Conﬁgure

Step Command Purpose

1 node(cfg)#port ethernet slot port Enters Ethernet port conﬁguration mode for the

interface on slot and port.

2 node(prt-eth)[slot/port]#medium (10 |

100 | 1000 | auto} (half | full)

Conﬁgures the interface on slot and port to

medium according to the selected option.

previous next