Filter
Top Products
IP interface configuration task list 122
SmartWare Software Configuration Guide 10 • IP interface configuration
Example: Create IP interfaces
The procedure illustrated below assumes that you would like to create an IP interface named lan Use the fol-
lowing commands in administrator configuration mode.
node>enable
node#configure
node(cfg)#context ip router
node(ctx-ip)[router]#interface lan
node(if-ip)[lan]#
Deleting an IP interface
Almost every configuration command has a
no form. In general, use the no form to disable a feature or func-
tion. Use the command without the
no keyword to re-enable a disabled feature or to enable a feature that is
disabled by default.
Deleting an existing interface in the IP context is often necessary.
Mode: Context IP
Example: Delete IP interfaces
The procedure below assumes that you would like to delete an IP interface named external. Use the following
commands in IP context configuration mode.
List the existing interfaces:
node(ctx-ip)[router]#interface <?>
<interface> New interface
lan Existing interface
wan Existing interface
external Existing interface
internal Existing interface
Delete the interfaces named eth3 with the no interface command:
node(ctx-ip)[router]#no interface external
List the interfaces again to check if the appropriate interface was deleted:
node(ctx-ip)[router]#interface <?>
<interface> New interface
lan Existing interface
wan Existing interface
internal Existing interface
Step Command Purpose
1 node(ctx-ip)[router]#no interface name Deletes the existing interfaces name