Support User Manuals

Patton electronic SmartNode 4110 Series IP Phone User Manual

Open as PDF

of 664

Activating CS context configuration 355

SmartWare Software Configuration Guide 31 • CS context overview

node(rt-tab)[HUNT-PU~]#cyclic

node(rt-tab)[HUNT-PU~]#route call 1 dest-interface IF-PUBLIC-PSTN1

node(rt-tab)[HUNT-PU~]#route call 2 dest-interface IF-PUBLIC-PSTN2

node(rt-tab)[HUNT-PU~]#exit

node(ctx-cs)[switch]#exit

node(cfg)#

Conﬁguring VoIP settings

Because we need G.723 as codec we enable DTMF relay:

node(cfg)#profile voip H323-VOIP-PROFILE

node(pf-voip)[H323-VO~]#codec 1 g723-6k3

node(pf-voip)[H323-VO~]#dtmf-relay

node(pf-voip)[H323-VO~]#exit

node(cfg)#

We want to use this proﬁle on our H.323 interfaces:

node(cfg)#context cs

node(ctx-cs)[switch]#interface h323 IF-COMPOFF-A

node(if-h323)[IF-COMP~]#use profile voip H323-VOIP-PROFILE

node(if-h323)[IF-COMP~]#exit

node(ctx-cs)[switch]#interface h323 IF-COMPOFF-B

node(if-h323)[IF-COMP~]#use profile voip H323-VOIP-PROFILE

node(if-h323)[IF-COMP~]#exit

node(cfg)#

Conﬁguring BRI ports

Next step is to conﬁgure the BRI ports and to bind the ports to the ISDN interfaces. We conﬁgure the layer 2

(Q.921) to use point-to-point mode and layer 3 (Q.931) for user or net operation mode:

node(cfg)#port bri 2 0

node(prt-bri)[2/0]#q921

node(q921)[2/0]#protocol pp

node(q921)[2/0]#q931

node(q931)[2/0]#uni-side net

node(q931)[2/0]#encapsulation cc-isdn

node(q931)[2/0]#bind interface IF-PBX1

node(q931)[2/0]#exit

node(q921)[2/0]#exit

node(prt-bri)[2/0]#no shutdown

node(cfg)#port bri 2 1

node(prt-bri)[2/1]#q921

node(q921)[2/1]#protocol pp

node(q921)[2/1]#q931

node(q931)[2/1]#uni-side net

node(q931)[2/1]#encapsulation cc-isdn

node(q931)[2/1]#bind interface IF-PBX1

node(q931)[2/1]#exit

node(q921)[2/1]#exit

node(prt-bri)[2/1]#no shutdown

node(cfg)#port bri 2 2

node(prt-bri)[2/2]#q921

node(q921)[2/2]#protocol pp

node(q921)[2/2]#q931

previous next