Filter
Top Products
Examples 594
SmartWare Software Configuration Guide 47 • VoIP profile configuration
Error Correction: enabled
HDLC: enabled
Dejitter Max Delay: 200ms
Modem
-----
Max. Bit Rate: 14400
Volume: -9.500dB
HDLC: enabled
DTMF
----
Relay: enabled
Mute Encoder: enabled
RTP
---
Payload Type NTE: 101
Description:
3. Create VoIP profile and give it a name. All settings have default values
4., 5. Remove the default codecs G.711alaw and G.711uLaw
6. Add codec g729 with silence-suppression enabled
7. Allow the dejitter buffer to compensate 100 milliseconds of network jitter.
8. Enable fax relay over T.38 protocol
9. Limit the maximum bit rate the fax devices can communicate with each other to 9600 kbps
10. Show the configured profile.
Soft phone client gateway
A soft phone client can only use G.711uLaw or G.723 codes, neither of which can use silence suppression,
DTMF relay, or fax.
1 node>enable
2 node#configure
3 node(cfg)#profile voip softPhone
4 node(pf-voip)[softPho~]#no codec g711aLaw64k
5 node(pf-voip)[softPho~]#codec g723-6k3 tx-length 30 rx-length 30 no-silence-sup-
pression
6 node(pf-voip)[softPho~]#no dtmf-relay
7 node(pf-voip)[softPho]]#show profile voip softPhone
VoIP Profile: softPhone
=======================
Used: by 0 module(s)
Codecs
------