Filter
Top Products
IP interface configuration task list 126
SmartWare Software Configuration Guide 10 • IP interface configuration
The following example shows how to define the MTU of the IP interface lan to 1000 and to adjust the MSS in
both directions to MTU-40. Use the following commands in IP context configuration mode.
node(ctx-ip)[router]#interface lan
node(if-ip)[lan]#mtu 1000
node(if-ip)[lan]#tcp adjust-mss rx mtu
node(if-ip)[lan]#tcp adjust-mss tx mtu
Configuring an interface as a point-to-point link
A point-to-point network joins a single pair of routers. It is in particular used for interfaces, which have a bind-
ing to a Frame Relay PVC.
Mode: Configure
Example: Configuring an interface as a point-to-point link
The following example shows how to define the interface lan as point-to-point link. Use the following com-
mands in configuration mode.
node(cfg)#context ip router
node(ctx-ip)[router]#interface lan
node(if-ip)[lan]#point-to-point
Displaying IP interface information
The
show ip interface command displays IP information for all interfaces. The command is available in
operator execution mode or in any of the administrator execution modes.
Mode: Operator execution or any administrator execution
Example: Displaying IP interface information
The following example shows how to display the IP information for all interfaces by using the
show ip
interface
command from operator execution mode.
node>show ip interface
------------------------------------------------------------
Context: router
Name: lan
IP Address: 172.16.40.77 255.255.0.0
MTU: 1500
ICMP router-discovery: enabled
ICMP redirect: send only
State: OPENED
Binding: ethernet 0 0 0/ethernet/ip
Step Command Purpose
1 node(cfg)#context ip router Selects the IP router context
2 node(ctx-ip)[router]#interface name Selects the defined interface name for configuration
3 node(if-ip)[name]#point-to-point Configures the interface ifname as point-to-point link
Step Command Purpose
1 node>show ip interface Displays the IP information for all interfaces