Filter
Top Products
RIP configuration task list 245
SmartWare Software Configuration Guide 23 • RIP configuration
Example: Enabling send RIP
The following example shows how to enable send RIP on IP interface wan.
node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip supply
Enabling an interface to receive RIP
By default an interface does not listen to routing information. This procedure describes how to enable interface
to receive RIP information
Mode: Interface
Example: Enabling receive RIP
The following example shows how to enable receive RIP on IP interface wan.
node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip receive
Specifying the send RIP version
By default, RIP 1compatible packets are sent. Alternatively, you can explicitly configure the RIP version to be
sent with the last command argument as following:
• 1—RIPv1
• 1compatible—RIPv1 compatible
• 2—RIPv2
This procedure describes how to select the sending RIP version on interface
Mode: Interface
Example: Specifying the send RIP
The following example shows how to select send RIP version 1compatible on IP interface wan.
node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip send version 1compatible
Step Command Purpose
1 node(if-ip)[name]#rip receive Enables receive RIP on interface name
Step Command Purpose
1 node(if-ip)[name]# rip send version {1 | 1compatible | 2} Selects send RIP version for inter-
face name