Filter
Top Products
Call router configuration task list 481
SmartWare Software Configuration Guide 40 • Call router configuration
Mode: Context CS
Example: Remove an entire routing table
node(cfg)#context cs
node(ctx-cs)[switch]#no routing-table MY-TABLE
Configure mapping tables
Mapping tables are used to modify the call setup message and thus influence the routing decision and or the
outgoing setup message leaving the call router. Mapping tables are identified by a name (string) and referenced
in the routing tables for execution. Like the routing table, a mapping table finds the best matching entry and
executes it; but unlike the routing table, the execution means manipulating a call property. Thus a mapping
table always examines one call property (the input-type) and changes another property (the output-type). As
for the routing tables the call router provides a number of different mapping table types. A mapping table looks
like the following:
Figure 64. Mapping table outline
Each table contains a header and one or more entries. The header declares the input and output-type of the
mapping table as well as its name.
Unlike a routing table, a call property pair characterizes a mapping table, the input and output-type. While the
input-type defines which call property is examined by the call router, the output-type defines which property is
modified once the best matching entry is found, for example, you may want to find a best matching entry in a
mapping table based on the presentation indicator and, once found, you want to manipulate the calling party
number of the call. In this case you chose an input-type of calling-pi and an output-type of calling-e164
There are three different kinds of call properties, calling party properties, called party properties and generic
properties. When a call setup is to be routed by the call router, most properties appear as calling and as called
party properties, for example, you have a calling party number and a called party number to examine. There
are other properties (e.g. the information transfer capability), which is a property of the whole call and not of
either party.
Step Command Purpose
1 node(ctx-cs)[switch]#no routing-table
table-name
Delete the routing table table-name.
Note: You do not have to enter the type of the table when
just deleting it. The type must only be specified when creating
a table.
Output-Type
Name REMOVE-CNPN
calling-e164
Key
restricted if USVOIP-A
Header
Entries
Input-Type calling-pi
Value