Filter
Top Products
Call router configuration task list 521
SmartWare Software Configuration Guide 40 • Call router configuration
node(if-isdn)[IF-LOCA~]#exit
node(ctx-cs)[switch]#interface h323 IF-NODE-B
node(if-h323)[IF-NODE-B]#route dest-interface IF-PBX-A
node(if-h323)[IF-NODE-B]#exit
node(ctx-cs)[switch]#interface sip IF-NODE-C
node(IF-NODE-C)[IF-NODE-C]#route dest-interface IF-PBX-A
node(IF-NODE-C)[IF-NODE-C]#exit
The configuration is now complete. Prior to activating the configuration enable the call router debug monitor
to check the loading of the call router elements.
node(cfg)#debug call-router
node(cfg)#context cs
node(ctx-cs)[switch]#no shutdown
02:14:30 CR > Updating tables in 3 seconds...
02:14:33 CR > [switch] Reloading tables now
02:14:33 CR > [switch] Flushing all tables
02:14:33 CR > [switch] Loading table 'TAB-ISDN-SERVICE'
02:14:33 CR > [switch] Loading table 'TAB-DEST-A'
02:14:33 CR > [switch] Loading table 'CAC-APPLE'
02:14:33 CR > [switch] Loading table 'CAC-ORANGE'
02:14:33 CR > [switch] Loading table 'CLI-MELON'
02:14:33 CR > [switch] Loading table 'MAP-CAC-APPLE'
02:14:33 CR > [switch] Loading table 'MAP-CAC-ORANGE'
02:14:33 CR > [switch] Loading table 'MAP-CLI-MELON'
02:14:33 CR > [switch] Loading table 'IF-LOCAL-BREAKOUT-precall-service'
02:14:33 CR > [switch] Loading table 'IF-PBX-A-precall-service'
02:14:33 CR > [switch] Loading table 'IF-NODE-B-precall-service'
02:14:33 CR > [switch] Loading table 'IF-NODE-C-precall-service'
node(ctx-cs)[switch]#
Configure partial rerouting
To save bandwidth and B-Channels, SmartWare supports partial rerouting. SmartWare accepts rerouting
requests from PBX, which want to push-back a diverted or forwarded call with a Rerouting Request. Smart-
Ware can generate such a reroute request to push-back a looped call. Both, acceptation and emission of rerout-
ing requests can be configured separately.
To prevent rerouting when a particular service is invoked in a call, services can be configured to allow or to for-
bid rerouting of calls of the service. In order that a call can be rerouted, all services participating in this call
must allow rerouting. In addition rerouting emit must be configured on the interface where this call comes in
and is routed out.
To accept or emit rerouting requests, see “Call reroute” on page 522.
To allow push-back, see “Allow Push-Back” on page 522.