Filter
Top Products
Location Service configuration task list 611
SmartWare Software Configuration Guide 51 • Location Service
Mode: Authentication outbound
Mode: Authentication outbound
Mode: Authentication outbound
Authentication inbound face
The authentication inbound face is used when you want to challenge other user agents.
Mode: Identity
An authentication entry establishes a link between an identity and a pair of credentials in an authentication-
service. To link multiple credentials to an identity, there must be one authentication entry in the authentica-
tion inbound face for each pair of credentials to link. The parameter username selects the entry in the authen-
tication-service to use. The parameter username can be omitted if and only if the name of the identity matches
the username in the authentication-service exactly.
Step Command Purpose
1 [node](authout)#authenticate authentica-
tion-service <authentication-service> [user-
name <username>]
or
[node](authout)#authenticate <index>
authentication-service <authentication-ser-
vice> [username <username>]
or
[node](authout)#authenticate before
<index> authentication-service <authentica-
tion-service> [username <username>]
or
[node](authout)#authenticate after
<index> authentication-service <authentica-
tion-service> [username <username>]
Adds a new authentication entry to the authentica-
tion outbound face. If more than one authentica-
tion entry has to be entered, the order of the list
can be modified by using the index and/or the
insert keywords before and after.
Step Command Purpose
1 [node](authout)#no authenticate [<index>] Removes the authentication entry at the index or
removes all authentication entries if no index is
given.
Step Command Purpose
1 [node](authout)#authenticate none Removes all authentication entries and disables
explicitly authentication outbound.
Step Command Purpose
1 [node](identity)[name]# [no] authentica-
tion inbound
Adds a new face to the identity. The no form of the
command removes an existing face with all content
in it.