Filter
Top Products
Location Service configuration task list 613
SmartWare Software Configuration Guide 51 • Location Service
Registration outbound face
The registration outbound face is used to register an identity on an external registrar. Then, the registrar for-
wards calls from the registered identity to your identity.
Mode: Identity
Mode: Registration outbound
Mode: Registration outbound
Mode: Registration outbound
Mode: Registration outbound
Step Command Purpose
1 [node](identity)[name]# [no] registration
outbound
Adds a new face to the identity. The no form of the
command removes an existing face with all content
in it.
Step Command Purpose
1 [node](regout)# [no] register [auto|none] Enables registration with auto or disables registra-
tion explicitly with none.
Step Command Purpose
1 [node](regout)# [no] registrar <host>
[<port>]
Configures the address of the registrar to send
your register requests. When no registrar is config-
ured, the register requests are sent to the first
domain entry in the location-service.
Step Command Purpose
1 [node](regout)# [no] lifetime <seconds> Configures the desired lifetime of the registration.
When no lifetime is configured the desired lifetime
is set to 3600 seconds.
Step Command Purpose
1 [node](regout)# [no] retry-timeout (on-cli-
ent-error|on-sysstem-error|on-server-
error) <seconds>
Configures the time to wait after a failed registra-
tion according to three different error categories.
After this time we begin to register from new. If no
retry-timeout is configured the retry-timeout is set to
10 seconds.