Filter
Top Products
H.323 interface configuration task list 436
SmartWare Software Configuration Guide 38 • H.323 interface configuration
Mode: Interface H.323
Example: Enable CLIP/CLIR support
The following example shows how to enable CLIP/CLIR support on the H.323 interface MyH323If.
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface h323 MyH323If
node(if-h323)[MyH323If]#clip-clir-support
Enabling ‘early-proceeding’ on H.323 interfaces
The
early-proceeding command can enable the early-proceeding feature on H.323. If this feature is enabled,
the gateway will immediately reply with an H.225 (H.323) call-proceeding message in response to a received
H.225 (H.323) setup message without waiting for a response from the destination.
Mode: interface h323 <if-h323>
Example: Enable early call disconnect
The following example shows how to enable early call disconnect on an H.323 interface named MyH323If.
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface h323 MyH323If
node(if-h323)[MyH323If]#early-disconnect
Enabling the early call connect (optional)
The
early-connect command can be enabled to open a data path before the call is connected to play inband
information from the ISDN side.
Mode: interface h323
Step Command Purpose
1
node(if- h323)[if-name]#clip-clir-support Enables CLIP/CLIR support on the H.323
interface
Step Command Purpose
1
[name](if-h323)[if-name]#early-proceeding Enables the early-proceeding feature.
Step Command Purpose
1
[name](if-h323)[name]#early-connect Enables the early-connect feature.