Support User Manuals

Patton electronic SmartNode 4110 Series IP Phone User Manual

Open as PDF

of 664

RADIUS configuration 107

SmartWare Software Configuration Guide 8 • RADIUS Client Configuration

Transactions between the RADIUS client and server are authenticated through the use of a shared secret, which is

never sent over the network—the same secret must thus be known to the server and the client by conﬁguration.

Using this secret as an encryption key, user passwords are sent encrypted between the client and RADIUS server.

Conﬁguring RADIUS clients

If the AAA proﬁles you have deﬁned make use of the RADIUS AAA method, you must conﬁgure the corre-

sponding RADIUS clients. To conﬁgure RADIUS clients, do the following steps:

Mode: Conﬁgure

Example: Conﬁgure the RADIUS clients as shown in ﬁgure 15.

node>enable

node#configure

node(cfg)#radius-client radius_deepblue

node(radius)[radius_~]#radius-server deepblue

node(radius)[radius_~]#shared-secret authentication 78f8a23b

node(radius)[radius_~]#exit

node(cfg)#radius-client radius_extern

node(radius)[radius_~]#radius-server 219.144.12.1

node(radius)[radius_~]#shared-secret authentication dd9351e13cc335

node(radius)[radius_~]#exit

node(cfg)#

node(cfg)#show radius-client

RADIUS clients:

radius_deepblue

radius_extern

node(cfg)#show radius-client radius_deepblue

AAA RADIUS Module: radius_deepblue

Authentication Shared Secret: 78f8a23b

Timeout: 6

Sessions:

UDP Interface:

Configured Server Hostname: deepblue

node(cfg)#show radius-client radius_extern

AAA radius Module: radius_extern

Authentication Shared Secret: dd9351e13cc335

Timeout: 6

Sessions:

UDP Interface:

Configured Server Hostname: 219.144.12.1

Step Command Purpose

1 node(cfg)#radius-client name Adds a RADIUS client with name name and

enters RADIUS-client conﬁguration mode

2 node(radius)[name]#radius-server host-

name

Sets the hostname (or IP address) of the remote

RADIUS server

3 node(radius)[name]#shared-secret

authentication secret

Sets the password shared between the RADIUS

client and the remote RADIUS server.

4 node(radius)[name]#exit Goes back to the parent conﬁguration mode

5 node(cfg)#show radius-client name Displays conﬁgured RADIUS servers

previous next