Filter
Top Products
Ethernet port configuration task list 148
SmartWare Software Configuration Guide 12 • Ethernet port configuration
Adding a transmit mapping table entry
The transmit mapping table defines the conversion of transmitting firmware-specific service class value into a
Layer 2 CoS to service class value. Each conversion is stored as a mapping table entry, so the transmitting map-
ping table consists of several mapping table entries.
This procedure describes how to add a transmit mapping table entry.
Mode: Configure
Example: Adding a transmit mapping table entry
The following example shows how to add a transmit mapping table entry, which converts a service class value
of 4 into a layer 2 class of service value of 2 for the Ethernet port on slot 0 and port 0.
node(cfg)#port ethernet 0 0
node(prt-eth)[0/0]#cos tx-map 4 as 2
Closing an Ethernet port
An Ethernet port can be closed with the
shutdown command. This command also disables and closes the IP
interface that is bound to that port. All static routing entries that are using this interface change their state to
‘invalid’ and all dynamic routing entries will be removed from the route table manager.
This command can be used as soon as an encapsulation type is defined and the port was bound successful to an
IP interface.
This procedure describes how to disable the Ethernet port on slot and port.
Mode: Configure
The no prefix causes to open the port with the interface to which it is bound.
Step Command Purpose
1 node(cfg)#port ethernet slot port Enters Ethernet
port configura-
tion mode for
the interface on
slot and port.
2 node(prt-eth)[slot/port]#cos tx-map service class value as layer 2 class of
service value
Adds a transmit
mapping table
entry, which
converts a ser-
vice class value
into a layer 2
class of service.
Step Command Purpose
1 node(cfg)#port ethernet slot port Enters Ethernet port configuration mode for the interface on
slot and port
2 node(prt-eth)[slot/port]#shutdown Disables Ethernet port on slot and port