Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Customer Support Information
Page A-5DOC Notification and Repair Information
A
This equipment returns answer supervision on all DID calls forwarded back
to the Public Switched Telephone Network. Permissible exceptions are
when:
— A call is unanswered
— A busy tone is received
— A reorder tone is received
Allowing this equipment to be operated in such a manner as not to provide
proper answer supervision signaling is in violation of Part 68 rules.
■ New Network Area and Exchange Codes. The MERLIN LEGEND
software does not restrict access to any new area codes or exchange
codes established by a local telephone company. If the user has
established toll restrictions on the system that could restrict access, then
the user should check the lists of allowed and disallowed dial codes and
modify them as needed.
■ Equal Access Codes. This equipment is capable of providing users
access to interstate providers of operator services through the use of
access codes. Modifications of this equipment by call aggregators to block
access dialing codes is a violation of the Telephone Operator Consumers
Act of 1990.
DOC Notification and
Repair Information 1
NOTICE: The Canadian Department of Communications (DOC) label identifies
certified equipment. This certification means that the equipment meets certain
telecommunications network protective, operational, and safety requirements.
The DOC does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure that it is permissible to
connect it to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the company’s inside wiring for single-line individual service may be
extended by means of a certified connector assembly (telephone extension cord).
The customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made
by the user to this equipment, or any equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment.