Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Common Administrative Procedures
Page 3-232System Features
3
Interdigit Timers 3
This procedure to program interdigit timers has not yet been implemented. If
situations occur where a caller is attempting to make an outside call and becomes
connected to an incoming call, the caller may not be able to put the incoming call
on hold or transfer the call. Setting interdigit timers to shorter times permits the
call to be put on hold or transferred. If you are experiencing these types of
problems, call the Lucent Technologies Helpline at 1 800 628-2888.
Allowed Lists 3
Use this procedure to establish Allowed Lists. These lists are telephone numbers
that can be dialed from specified telephones, regardless of any calling restrictions
assigned to the telephones.
A maximum of eight lists (numbered 0 through 7), with a maximum of 10 numbers
each (numbered 0 through 9) allowed. Each allowed number can be no more than
six digits (an area code plus an exchange) or six digits with a leading 1, where
required.
If you program 0 as the first digit of a list entry, any toll restriction assigned to the
extension is removed for calls that can be placed by a toll operator.
Special characters (such as Pause) are not permitted in Allowed List entries.
Summary: Allowed Lists 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 6g, Call Restriction Assignments and Lists
Factory Setting Not applicable
Valid Entries Area code/exchange (1- to 6-digits with leading 1, if
necessary)
Inspect No
Copy Option No
Console Procedure
→ →Dial list no. and entry no.→
→Drop→Dial no.→ →
PC Procedure → →Type list no. and entry no.→ →
+
→Type no.→ →