Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming with SPM
Page 2-53System Programming
2
■ Identify telephones with voice signal pairs for the Voice Announce to Busy
feature
■ Identify telephones that need the Simultaneous Voice and Data feature
■ Restore system programming information
■ Identify the Music On Hold jack
When the system is forced idle, the following occurs: multiline telephone users
hear a reminder tone that indicates the telephone cannot be used; display
telephone users see the message
; single-line telephone
users do not hear a dial tone.
Line or Trunk Idle 2
Since these procedures require the line or trunk to be idle
only
at the instant of
programming, the line or trunk is not forced idle. The following procedures can be
performed only when the line or trunk being programmed is idle:
■ Identify loudspeaker paging line jack
■ Assign trunks to pools
■ Specify incoming or outgoing DID- or tie-trunk type
■ Specify tie-trunk direction
■ Specify tie-trunk E&M signal
Extension Forced Idle 2
When an extension is forced idle, no calls can be made or received on that
extension. The following procedures can be performed only when the extension
being programmed is idle:
■ Assign call restrictions
■ Assign pool dial-out restrictions
■ Copy extension assignments
■ Assign lines, trunks, or pools to extensions
■ Assign labels to a personal directory
■ Use centralized telephone programming
When the extension is forced idle, the following occurs: multiline telephone users
hear a reminder tone that indicates the telephone cannot be used; display
telephone users see the message
; single-line telephone
users do not hear a dial tone.