Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming with SPM
Page 2-74Upgrading the System
2
Table 2–14. Programming Needed after Upgrade to Release 5.0
Table 2–13. Continued
Feature Sequence
PRI Call-by-Call
Services Table
To select MCI Toll Call-by-Call Services for a
DMS-250 or DEX600E switch type:
→ → → →
→ → →List
no.
→ → → or
→
To specify local exchange carrier Dial Plan Routing
services for a DMS-100 switch type:
→ → → →
→ → →List
no.
→ → → or
or →
Feature Sequence
CTI Link This is a Maintenance step. Start the procedure from
the main menu, not the System Programming screen.
Busy out the board first:
Menu
→ → →Dial slot no.→
→ →
Program the CTI Link (the switch must be in
Hybrid/PBX mode):
→ →Dial extension no.→ →
→
This is a Maintenance step. Start the procedure from
the main menu, not the System Programming screen.
Restore the slot:
Menu
→ → →Dial slot no.→ →
→ .
NOTE:NOTE:NOTE:
If the MLX module containing the CTI Link is the first module,
use the SPM program to busy-out the slot.
Continued on next page