Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming Procedures
Page 4-246BRI Facilities
4
Console Display/Instructions Additional Information PC
Erase the current DN.
Enter the new DN.
Dial or type [
xxxxxxxxxx
].
Save your entry.
Select
.
Return to the System Programming menu.
Select
three times.
Timers 4
Use this procedure to set timer thresholds.
!
CAUTION:
!
CAUTION:
The factory settings for these thresholds are standard and rarely need to be
changed. If you are not sure of the correct timer and threshold settings for
your BRI lines and trunks, check with your Lucent Technologies
representative before you make a change. Incorrect settings can cause
your BRI lines and trunks to malfunction.
If the network does not respond before the programmed time, the system takes
the appropriate corrective action.
The timers are listed below.
■ T200 Timer. Minimum time that the link layer waits for an acknowledgment
of a message sent from the communications system to the network.
■ T203 Timer. Maximum time that the link layer can remain inactive.
xxx
= line number selected in Step x.
Press Drop. +