Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Common Administrative Procedures
Page 3-251Night Service
3
NOTE:NOTE:NOTE:
For Release 2.1 and earlier, after setting Start and Stop time for Night
Service you must use the following procedure to set the current day of the
week for Night Service.
→ →Dial the current day of the week→ →
If system programming information is being loaded into memory from a backup
diskette, the current day of the week must be reset.
Night Service can be turned off by using the following procedure:
→ →Dial → →
Summary: Night Service with Time Set 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 9c, Night Service: Time Set
Factory Setting Not applicable
Valid Entries Day: 0 to 6; Time: 0000 to 2359
Inspect No
Copy Option No
Console Procedure To add or change start/stop time:
→ →Drop→Dial start day and time→
→ →Drop→Dial stop day and time→
→
To activate/deactivate:
→ → or → →
PC Procedure To add or change start/stop time:
→ →
+
→Type start day and time→ →
→
+
→Type stop day and time→ →
To activate/deactivate:
→ →
or
→ →