Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Common Administrative Procedures
Page 4-434Data Features
4
Console/Display Instructions Additional Information PC
Assign or remove the voice/data pair.
Select
or
.
You may continue to assign or remove additional
voice/data pairs by repeating Steps 4 and 5.
Return to the System Programming menu.
Select
.
2B Data 4
Use this procedure to program an MLX port for 2B data capability. Assigning a
port for 2B data allows both B-channels of a single MLX port to be used for
speeds up to 128 Kbps on data calls. 2B data capability is available on in Release
4.0 and later.
Consider the following when programming ports for 2B data capability:
■ The extension number of the port cannot be the first or fifth port on an MLX
module. These ports are designated as potential operator ports and cannot
be used for 2B data connections.
■ The extension number must correspond to the adjunct extension number of
an MLX port. By default these extensions begin with “7.”
■ Devices that are not intended for 2B data should not be connected to a port
programmed for 2B data. These devices probably will not work.
Summary: 2B Data 4
Programmable by System Manager
Mode Key, Hybrid/PBX
Idle Condition Required
Planning Form Data Form 2b, Digital Data Workstation
Factory Setting None
Valid Entries Adjunct extension number up to four digits
Inspect Yes
Copy Option No
Console Procedure
→ →Dial adjunct ext. no.→ →
→
PC Procedure → →Type adjunct ext. no.→ → →