Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming Basics
Page 1-18Programming Procedures
1
The first branch procedure from sample Step 3 is shown below.
AT&T Toll Procedure
Console/Display Instructions Additional Information PC
Specify a service.
Save your entry.
Select
.
Repeat Steps 1 and 2 of the main procedure for each toll group number.
For additional toll services, go to Step 1; then continue with Step 5.
Return to Step 4 of the main procedure.
Each branch procedure is self-contained and begins with Step 1. Be sure to
complete all of the steps in a branch procedure before you return to the main
procedure.
The examples in the following text refer to Steps 1 through 5 of the AT&T Toll
Procedure (above), which is a branch of the Network Services procedure.
When you are to repeat a step
within the branch procedure,
you are instructed to
go to that step. For example, at Step 4 of the branch procedure you would go
back to Step 1 of the branch procedure and repeat branch Steps 1 through 4 for
additional toll services. If you did not need to enter any other toll services, you
would continue with Step 5 of the branch procedure.
When a branch step instructs you to
return to the main procedure,
the branch
procedure is complete. At Step 5 of the branch procedure you would return to
Step 4 of the Network Services procedure to continue. In some cases, you can
select
( on the PC) to return to the menu where the branch begins; these
are noted in specific programming procedures. In cases where completing the
branch procedure also completes the main procedure you are instructed to select
( on the PC) one or more times to return to the system programming
menu.
xx
= number entered in Step 5
Press the button or function key next to
your selection.