Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming Procedures
Page 4-21System Renumbering
4
Block Renumbering 4
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
See “Block Renumbering” on page 3–16
for detailed information.
!
CAUTION:
!
CAUTION:
Select on the console or on the PC when you have finished
renumbering extensions. If you press Home, extensions may remain in the
forced idle condition (indicated when the LED next to each DSS button is
on). To restore extensions to their normal operating state, restart the
system.
Summary: Block Renumbering 4
Programmable by System Manager
Mode All
Idle Condition System idle
Planning Form Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Factory Setting Not applicable
Valid Entries Old and new extension numbers
Inspect Yes
Copy Option Yes
Console Procedure
→ →Select type of group→Dial no. of first
group member
→ →Dial no. of last group
member
→ →Dial new beginning no.→ →
→ →
PC Procedure → →Select type of group→Type no. of first group
member
→ →Type no. of last group member→
→Type new beginning no.→ → → →