Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Common Administrative Procedures
Page 3-29System Operator Positions
3
Console Display/Instructions Additional Information PC
Specify the QCC extension as a QCC position.
Assign or remove the QCC operator extension.
Select
or
.
You may continue to assign or remove QCC
operator positions by repeating Steps 4 and 5.
Indicate that you have finished entering all positions.
Select
The session is terminated and the system
restarts. You must enter system programming
again to continue.
DLC Operator Positions 3
DLC operator positions can be assigned to the first and fifth extension jacks on
the first modules with either digital or analog multiline extension jacks. A
maximum of eight DLC operator positions can be assigned. Any combination of
operator positions can be assigned as long as there are no more than four QCC
operator positions and no more than a total of eight operator positions.
Use this procedure to specify extensions that serve as central answering positions
for all incoming calls, either for Call Management Systems (CMSs) connected to
operator extension jacks, or as calling group supervisor extensions. (You do not
need to use this procedure in a Key or Behind Switch system unless you have
more than one DLC position.) For a new system, remove the factory-set DLC
operator position assignment for any telephone not used as an operator position.
Lines and trunks are assigned to individual buttons.
The system programming console can have several incoming calls ringing
simultaneously.
Each CMS requires two DLC operator positions to connect the equipment and
one position to serve as CMS supervisor.
If no DSS is attached:
SP: “Entering an Extension”
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 6.
On = extension is currently assigned
Flashing = ext. can be assigned as a QCC
Off = ext. cannot be assigned as a QCC