Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming Procedures
Page 4-112DS1 Facilities
4
Console/Display Instructions Additional Information PC
Save your entry.
Select
.
Return to the System Programming menu.
Select
twice.
If you are using PRI Facilities, go to
“Zero Code Suppression.”
Zero Code Suppression 4
Use this procedure to specify zero code suppression for the 100D module as AMI
zero code suppression (AMI-ZCS) or bipolar eight zero suppression (B8ZS). Your
selection must match the suppression at the far end of the DS1 facility.
NOTE:NOTE:NOTE:
In Release 6.0 and later systems, use bipolar eight zero suppression
(B8ZS) for tandem PRI trunks.
Summary: Zero Code Suppression 4
Programmable by System Manager
Mode All
Idle Condition 100D module idle
Planning Form Form 3b, Incoming Trunks: DS1 Connectivity (100D module)
Factory Setting AMI-ZCS
Valid Entries AMI-ZCS, B8ZS
Inspect No
Copy Option No
Console Procedure
→ →Dial slot no.→ →
→ or → → →
PC Procedure → →Type slot no.→ → →
or
→
→ →