Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming Procedures
Page 4-14System Renumbering
4
Valid Entries 0000 to 2359
Inspect No
Copy Option No
Console Procedure
→ →Drop→Dial current time→ →
PC Procedure → →
+
→Type current time→ →
System Renumbering 4
The procedures in this section are used to assign the 2-digit, 3-digit, and Set Up
Space numbering plans for the local MERLIN LEGEND Communications System.
NOTE:NOTE:NOTE:
System Renumbering is called
Flexible Numbering
in the MERLIN II
Communications System. This is
not
the same as Board Renumbering, an
option used when modules in the control unit are changed.
Do not attempt to assign a numbering plan without Planning Forms 2a, System
Numbering: Extension Jacks; 2b, System Numbering: Digital Adjuncts; and 2d,
System Numbering: Special Renumbers. Form 6a, Optional Operator Features, is
needed to assign a DSS Page button. This section contains the following
programming procedures:
■ Select System Numbering Plan
■ Direct Station Selector (DSS) Page Button Assignment
This section contains summaries of the following procedures which are described
in detail in Chapter 3, “Common Administrative Procedures.”
■ Single Renumbering
■ Block Renumbering
■ Non-Local Dial Plan Renumbering (Release 6.0 and later systems only)
For the local system, you then select only one of the numbering plans (2-digit
numbering, 3-digit numbering, or Set Up Space numbering). In addition, you may
need to perform single and/or block renumbering. You do not need to assign DSS
Page buttons unless the system programming console or one of the operator
positions is connected to a DSS. No matter which procedures you need to
perform, assign the numbering plan first, then do single and/or block renumbering,
and finally, assign DSS Page buttons (if necessary).