Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming with SPM
Page 2-19Accessing SPM
2
■ The password prompt appears on the screen when the connection is
made. (You may have to press more than once to get the password
prompt.)
■ If the PC is in a remote location and your system has not activated the
Remote Access feature, do the following:
— Use the main telephone number to place a voice call to the system
on the line to which the modem is connected.
— Instruct the operator to transfer you to the modem (by pressing
Transfer, dialing
,
then hanging up the telephone).
— To put the modem on line, type
and press , then hang
up the telephone.
NOTE:NOTE:NOTE:
If you enter a telephone number of fewer than 11 digits, you must end it with
a pound sign (#).
To access SPM through a local or remote modem connection, follow the steps
below.
Set up the appropriate physical connections between the PC and the control
unit. See “Connecting the PC” on page 13.
Type
and press to display the SPM Welcome screen shown below.
If you wish to program in a language other than the current language set for SPM, see
“Set the Programming Language” on page 2–18
.
Press any key to display a blank screen on which you can enter modem
commands. (You may have to press the key several times.)
Make a data connection to the modem of the control unit.
See “Modem Connections” on page 18.
When the connection is made, the password
prompt appears as shown in Step 4.
X.XX
= current version of SPM