Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Common Administrative Procedures
Page 4-412UDP (Uniform Dial Plan) Routing
4
UDP Other Digits 4
Use this procedure to specify other (extra) digits that must be added by the
system to the beginning of the dialed digits when calls are placed on an identified
route. You may need to prepend a digit in order to accommodate the 5-digit
numbering of DEFINITY Communications System extensions in your private
network. For more information about techniques for handling these non-local dial
plan extension numbers “Non-Local Dial Plan Extension Ranges” on page 3–19.
The user does not use a Pool button or pool dial-out code. Therefore, the dialed
digits correspond to the non-local dial plan numbering.
NOTES:
1. UDP pool routes must be programmed before you assign digit
absorption.
2. Do not use this procedure to overcome conflicts between local and
remote extension numbering. Such conflicts can result in numerous
problems with system features.
A maximum of 20 digits can be added, in any combination of digits 0 through 9.
Special characters such as switchhook flash, Stop, and # cannot be included as
extra digits. Pause is allowed in every position but the first.
Summary: UDP Other Digits 4
Programmable by System Manager
Mode Hybrid/PBX
Idle Condition Not required
Planning Form Non-Local Dial Plan Administration Form in the Installation
Specification
Factory Setting 0
Valid Entries Up to 20 digits (any combination of 0 to 9)
Inspect No
Copy Option No
Console Procedure
→ →Dial pattern no.→ →
Dial route no.→ → →Drop→
Dial digits to add→ → → → →
PC Procedure → →Enter pattern no.→ →Type route no.→
→ →
+
→Type digits to add→ → →
→ →