Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Programming with SPM
Page 2-49Using SPM
2
■ Restore is terminated under the following conditions:
If fewer boards are listed on the disk than on the control unit
If any real board is out of sequence with the boards listed on the disk
If phantom boards are not listed last
If the operating mode of the system being restored is Hybrid/PBX, but the
control unit processor module has been modified to operate only in Key
mode
■ A successful restore is followed automatically by a Restart (cold start)
!
WARNING:
An unsuccessful or terminated restore results in a System Erase
(frigid start). All calls are dropped. The system configuration is
erased. All system programming is lost and the system returns to the
factory settings. If the restore is being done remotely, the connection
is dropped immediately. If this happens, attempt to reconnect to the
control unit and immediately perform another restore. If this is not
successful, programming must be restored on site.
Follow the steps below to perform a restore.
At the SPM Main Menu, press to select
.
Follow the instructions for a floppy or a hard disk.
A second window appears which displays the
option and a directory
listing for C:\spm\backup.
■ If you are performing a Restore with a file saved on a floppy disk, go to
Step 3.
■ If you are performing a Restore with a file saved on the hard disk, go to
Step 4.