Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Programming
555-660-111
Issue 1
February 1998
Common Administrative Procedures
Page 3-16System Renumbering
3
Console Display/Instructions Additional Information PC
Enter the new extension.
Save your entry.
Select
or
.
If you use
to renumber the next item ( )
displayed on Line 1, return to Step 7.
Return to the System Programming menu.
Select
two times.
Block Renumbering 3
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
!
CAUTION:
!
CAUTION:
Select on the console or on the PC when you have finished
renumbering extensions. If you press Home, extensions may remain in the
forced idle condition (indicated when the LED next to each DSS button is
on). To restore extensions to their normal operating state, restart the
system.
Summary: Block Renumbering 3
Programmable by System Manager
Mode All
Idle Condition System idle
**** = item selected in Step 4
xxxx
= extension entered in Step 5
SP: “Entering an Extension”