Filter
Top Products
APPENDIX G. USING THE EYEBEAM SIP SOFTPHONE G-7
Using eyeBeam with Strata CS _____________________________
This following table describes how eyeBeam features interact with Strata CS.
Feature Directions
Dialing a number
Dial numbers just as you would from a Strata CS
phone, including access codes to place external calls.
You can dial Strata CS extensions or access the
telephone commands without an access code.
Note that if the eyeBeam phone is set up as a Strata
CS external station, you cannot dial SIP addresses
from it.
Place a call by clicking the Dial icon:
You can either dial the number first, then click the
icon, or click the icon first, then dial the number.
Note: When placing a Strata CS call that requires dialing an access code from an eyeBeam phone,
you do not hear dial tone after dialing the access code. You can continue dialing the number and the
call will be placed correctly. Or, to hear dial tone, you can press the Dial button again after dialing the
access code—for example, Dial, 9, Dial—and then dial the number.
Ending a call
To end a call, click the End Call icon:
Do Not Disturb
Click the phone’s DND button to turn on the Do Not
Disturb Strata CS personal status.
Auto Answer
Click the phone’s AA button to turn on automatic
answering of incoming calls, similar to Strata CS’s
hands-free answering.
You can use Strata CS call screening in combination
with the eyeBeam auto answer feature.
Auto conferencing
Not supported with Strata CS. Use Strata CS
commands to create conference calls (see “Creating
conference calls” on page 12-12).