Filter
Top Products
APPENDIX G. USING THE EYEBEAM SIP SOFTPHONE G-5
Q User name. Enter one of the following:
Q If you have an external station. Enter a name that matches the Userinfo field
in your external station configuration as shown in Tools > Options, Phone \
Station Features tab. (See
“Configuring a SIP phone” on page 6-14.)
Q If you don’t have an external station. Enter a name that matches the Userinfo
of SIP URI
field of the SIP account that you want to use with the phone, as
shown in Tools > Options, Personal \ SIP Account tab. (See
“Customizing SIP
accounts” on page 18-19.)
Q Password/Authentication user name. Enter the authentication credentials your
system administrator provided (or leave blank if not required by your system).
Q Domain. Enter the name or IP address of the Strata CS SIP Span to which this phone
is registered, as provided by your administrator.
7. Under Domain Proxy, check both Register with domain and Use as outbound
proxy
.
8. Click the SIP Accounts \ Add a New SIP Account \ Advanced tab and uncheck Send
SIP keep alives
.
9. Click the Media \ Audio \ Devices tab. Uncheck Enable VAD.
Disabling VAD creates a more natural audio sound, since the eyeBeam will transmit
audio continuously rather than stopping transmission when it doesn't detect voice
(which results in silence gaps). Note that disabling VAD increases the bandwidth used
during phone calls since audio is always transmitting.
10. Click the Media \ Audio \ Advanced \ Codecs tab. The following codecs on the
eyeBeam are supported by Strata CS:
Q G711 uLaw.
Q G711 alaw.
Q GSM.
Q G729.
For best results, arrange the codecs in the Enabled Codecs pane in the same
preference order as provided by your system administrator.
11. Choose the System \ General tab. Configure the following settings:
Q Auto answer. Enter the amount of time that the phone rings before connecting
audio, when Auto Answer is enabled.