Filter
Top Products
330 Telephony Hardware Selection and Settings
P0993133 03
Set the media bay module DIP switches
Before you install the media bay modules into the Business Communications Manager housing,
you need to set the DIP switches. Make a note of these settings either on the chart shown in Table
52 on page 328 or in the Programming Record forms.
Follow these steps to set the DIP switches:
1 Locate the DIP switches on the module.
Figure 200 Switches on the media bay module
2 Set the switches to correspond with the settings you chose “Determine module DIP switch
settings” on page 326.
3 Repeat for each media bay module you want to install.
6543 21
Off
On
Underside of the
media bay module
DIP switches
Back of the media bay module
123456
On
Off
Rear view of the media bay module
Module is
right-side up