Filter
Top Products
222 Chapter 10 Replace Data Cards and Processing Hardware
P0993133 03
8 Partially insert the base function tray in the platform base chassis (see “Install the base
function tray” on page 151). Ensure you do not pinch or damage any cables.
9 Install the base function tray bezel. See “Install the base function tray bezel” on page 154.
10 Move the base function tray latches to the locked position and install the latch screws.
11 Insert all connectors in the correct locations on the base function tray face.
12 Restore the unit to operation. For details, refer to “Restart the System after Maintenance” on
page 147.
13 This procedure is complete.
Initialize a new WAN card
Use this procedure to configure the Business Communications Manager to recognize a new WAN
card installation.
1 When the Business Communications Manager system is operational, display the configuration
main menu through a telnet session. See “Display the configuration menus” on page 139.
Refer to Figure 148
Figure 148 Configuration main menu display
2 Select option 8: Restart the system. Select “R” to confirm a restart.
3 Observe the base function tray LEDs. Wait for the system to completely shut down - indicated
by flashing LEDs.
Warning: Protect the hardware components against damage from electro-static
discharge. Always wear a ground wrist strap before you handle components. Always place
the components in static-free container.