Filter
Top Products
Chapter 4 Install, remove or replace the Media Bay Modules 121
Installation and Maintenance Guide
Wire Media Bay Modules to Internal Connections
After you have the trunk modules wired, you can install the wiring to the station modules. These
are the modules which connect to the internal telephone sets.
All station module wiring uses 25-pair cable with a female amphenol connector at the module end.
Follow these steps to connect the wiring for the DSM 16, DSM 32, ASM 8, or 4X16 modules:
1 Wire 16 wire pairs from the amphenol connector to the local connecting blocks (BIX) so they
connect to the 16 station sets you want connected to this module.
Use Table 13 and Figure 71 on page 122.
For an overview of BIX wiring conventions, refer to the Business Communications Manager
3.0 BIX Box Wiring Guide.
Note: DSM 32 modules require two 25-pair cables.
Note: Use 16 wire pairs from each connector for the DSM 32.
Note: If you are connecting an DSM 16, 4X16, or DSM 32, use Table 13 on page 122.
If you are connecting an ASM 8, use the Table 14 on page 123.