Filter
Top Products
Chapter 4 Install, remove or replace the Media Bay Modules 115
Installation and Maintenance Guide
Remove a media bay module from the expansion unit
Use this procedure to remove a media bay module from the Business Communications Manager
expansion unit. Remove the media bay modules after the system is powered down.
1 Remove any cabling from the media bay module faceplate.
2 Power down the Business Communications Manager expansion unit system (see Shut down
the system on page 110).
3 Remove the expansion unit front bezel.
4 Grasp the right edge of the MBM ejector lever. Pull outward to eject the media bay module.
Refer to Figure 65.
Figure 65 Remove the expansion unit front bezel
5 Grasp the top and bottom edges of the media bay module. Remove the media bay module from
the Business Communications Manager expansion unit. Place the media bay module in a
clean, safe and static free area.
6 This procedure is complete.
Replace a Media Bay Module
When media bay modules require replacement, follow the steps in this section.
Warning: This section describes replacing a module with the same type of module. If you
want to replace a module with a different type of module, you must treat it as a new
installation. Refer to Chapter B, “Telephony Hardware Selection and Settings and review
Figure 200 on page 330 to ensure the new module does not overrun any lines already
assigned to other modules.
Business Communications Manager expansion unit
1. Push against the bottom
2. Pull out from the top
media bay module latches