Filter
Top Products
Chapter 5 Business Communications Manager System Startup 139
Installation and Maintenance Guide
Display the configuration menus
To perform this procedure, the Business Communications Manager must be correctly powered up,
as described in “Check system power and status” on page 129.
1 Attach the null modem cable to the serial port on the Business Communications Manager.
2 Attach the other end of the null modem cable to the serial port on the terminal or computer.
3 Ensure that the Business Communications Manager and your terminal or computer are turned
on.
4 If you are using a computer, start your VT100 terminal program.
5 Press <ENTER>.
6 When prompted for a User ID, type:
ee_admin <ENTER>.
7 When prompted for a Domain, press <ENTER>.
8 When prompted for a Password, type:
eedge <ENTER>
The Main Menu screen appears. Refer to Figure 76.
Figure 76 Main Menu
Note: The location of the transmit (TX) and receive (RX) pins on your terminal can vary.
Refer to your terminal or computer documentation to confirm pin locations.
Note: If the Initialization Menu screen appears instead of the Main Menu shown above,
your Business Communications Manager system is not initialized correctly.