Filter
Top Products
Chapter 4 Install, remove or replace the Media Bay Modules 111
Installation and Maintenance Guide
Install a media bay module in the Business Communications
Manager platform base chassis
Use this procedure to install a media bay module in the Business Communications Manager
platform base chassis. Only install the media bay modules when the system is powered down.
1 Ensure that the switches on the media bay module are set correctly. For information about how
to set the switches, refer to “Set Media Bay Module Dip Switches” on page 322.
In the case of FEM modules, the switches activate the front ports. Ensure that the switches
accurately reflect the ports you require. Refer to “FEM switch settings” on page 344.
2 Select an open media bay.
3 With the face of the media bay module facing toward you, insert the media bay module into
the open bay.
4 Push the media bay module completely into the unit. You will hear a click when the module is
firmly seated in the media bay.
5 Repeat steps 2 to 4 for each media bay module you want to install.
Install a media bay module in the expansion unit
Use this procedure to install a media bay module in the Business Communications Manager
expansion unit chassis. Install the media bay modules when the system is powered down.
1 Ensure that the switches on the media bay module are set correctly. For information about how
to set the switches, refer to “Set Media Bay Module Dip Switches” on page 322.
In the case of FEM modules, the switches activate the front ports. Ensure that the switches
accurately reflect the ports you require. Refer to “FEM switch settings” on page 344.
2 Select an open media bay.
3 With the face of the media bay module facing toward you, insert the media bay module into
the open bay. Ensure that any cables at the rear of the module are clear of the platform base
chassis.
4 Push the media bay module into the unit. You will hear a click when the module is firmly
seated in the media bay.
5 Repeat steps 2 to 4 for each media bay module you want to install.
6 Install the front bezel on the expansion unit
7 This procedure is complete.