Filter
Top Products
130 Chapter 5 Business Communications Manager System Startup
P0993133 03
1 If the base function tray Power LED does not light:
a Disconnect the power cords.
b Check all cables and power connections. Ensure that the ac outlet has power.
c Reconnect the power cords.
2 If the Power LED is red and there is no power, use a paper-clip to select the reset button.
Alternatively power cycle the system to restart.
3 You are now ready to connect the system to the network and initialize it.
When the system power is on, and the system has successfully booted, the power and status LEDs
on the faceplates of the media bay modules are lit and remain constant. Figure 73 shows an
example of a media bay module and the LEDs on the module faceplate.
Figure 73 Module power and status LEDs
Temperature Temperature is
below threshold.
N/A Sensor is
non-operational
or Temperature
is out of range.
N/A
Fans All installed fans are
working
N/A Fan failure. N/A
Note: You can monitor the state of the Business Communications Manager LEDs
from your computer. Refer to “Access the System Status Monitor to Monitor
LEDs” on page 292.
Table 16 Business Communications Manager LED states (Continued)
LED
Label
Description Green LED On Green LED Flash
Red LED On
(Only)
Green LED Off
All modules have a
power
and
status
LEDs
DSM16